How To Replace A Circuit Breaker Safely

Electrical circuit breakers are likely the most important safety feature in a building. A circuit breaker measures the actual amount of heat produced by your current or by the magnetic field created by your small coil inside the actual breaker. Whenever the current becomes too high, the breaker will cut off the circuit to stop it. Fuses serve the same function yet could only be used once. Those who have blown a fuse could tell you it is much better to have circuit breakers.

A circuit breaker is connected to an electric powered circuit and was designed to stop the energy flow though the circuit in the event there’s a surge, arc, or short. Occasionally, even so, a lot of these breakers go bad, and you will need to understand how to replace a circuit breaker. Follow the measures to learn how to replace a circuit breaker. Find the principal circuit breaker box. Some homes may have 1 large main circuit breaker box as well as smaller branch circuit breaker boxes.

Locate the actual faulty breaker. A tripped circuit breaker is halfway between the actual on and shut off placement. Before assuming a circuit breaker has to be replaced, try resetting the actual circuit breaker by turning off all lights and unplugging all devices on that circuit. Then turn the actual breaker back to the actual location. Several breakers have to be turned all the way before they can be turned back on. Try out the actual circuit breaker by turning on the circuit breaker, and also then add the actual devices 1 at a time. Use a voltage tester to see in cases where energy is going out over the wire attached to the actual breaker. Shut off the side branch circuit breaker boxes, followed by the principal power.

Shut down the individual breakers. Remove the actual screws holding the faceplate using a Philips screwdriver. Read the actual label on the principal energy switch to determine what kind of circuit breaker box you own. Loosen the screws with the actual wires found on the faulty circuit breaker. Remove the circuit breaker in the panel. Discard the old circuit breaker.

Replace the old circuit breaker with the new 1. The replacement unit breaker must hold the same amperage and be the same type as the actual main breaker. Snap the circuit breaker back into the actual same place as the actual old on the section. Place the actual wires in the new circuit breaker as they were in the old one. Tighten the actual screws. Don’t over tighten. Replace the actual circuit panel’s faceplate. Turn on the principal energy, followed by the individual breakers.

Learn more about how to replace a circuit breaker. Stop by Sell Electrical Surplus NOW!

VN:F [1.9.22_1171]
Rating: 0.0/10 (0 votes cast)

Tags:

Author:

This author has published 23 articles so far.

Comments are closed