Steps On Doing A Driveway Sealcoating

Sealing the driveway would not only make it appealing. It will also provide protection against the changing weather. Doing this will be a worthy investment for you.

If you think of sealing the driveway, do it while it is still not snowing or not raining. You could check driveway sealcoating Somerset County so you will have an idea on how it will look. If you like to do it, read the procedures on the next paragraphs.

Somerset is a census designated place in New Jersey. It has a total area of about six square miles. There are a lot of places you can go to. Somerset NJ is among the most exciting places one could visit.

First thing you have to do is to look for any trouble spots. Make sure you take note of where are the cracks, stains, holes or the areas which are crumbling. Check the ends and the edges of the driveway as they are the parts which are very prone to damage. If you saw that there are stains from oil or grease, remove them with the use of a hot, soapy water and a brush. You need to make sure it gets removed. If scrubbing it is not effective, you can use a degreaser for that.

You would see some cracks that could be big or small. Before applying any seal, fix them. If it does not get fixed, it can be wider and become longer as time goes by. Many fillers are being sold in stores that you may use to fix it. Do not forget to read and follow the given instructions to have the best result. Before you apply some filler, clean those cracks first. You need to get rid of the dirt, grass or some stones in it.

If there are holes, patch them. Brush the area to make it clean. Remove dirt in it too. You can now apply asphalt on the hole. Make sure you compact that area so that all of it will get filled. Repeat the same process until the hole is filled completely. If it will sink, repeat the process of patching. Leave it for about twenty four hours before placing the seal.

Clean your drive way properly after that. Sweep and use a hose so you could rinse its surfaces. Begin on the highest section going down to its edge. Prior to applying some sealer, verify the weather condition. Everything will dry for approximately 2 to 3 days. You have to see to it that it will be sunny the whole week.

If you would be applying it already, evenly spread some sealer. There will be ones that need equipment with long handles and a squeegee on its end. There will be ones that need equipment that are short handled. Repeat it until you applied all of it evenly. Let its first coat dry for 6 to 12 hours. Apply its second coat. Block your drive way and leave that for approximately 24 hours.

When it is done, you will notice that it has become more appealing. Your home looks better with the change. Follow those steps stated above if you plan doing it.

You can visit www.asphaltmaintenancenj.net for more helpful information about Procedures For Doing A Driveway Sealcoating.

VN:F [1.9.22_1171]
Rating: 0.0/10 (0 votes cast)

Tags: , , ,

Author:

This author has published 67 articles so far.

Comments are closed